Boss Audio Systems DVD-2800T User Manual page 25

TYPE A (FOR MONITOR) (SEE FIG.1):
This unit is a separate TV box that can receive DVD/VCD's AV signal and output the
signal to the monitor that connected to the unit. And the unit also can receive TV
signal through the antenna input jack.
1 DC 12 V IN
Through this DC 12V IN jack (1), provide DC 12V power supply to the unit.
2 POWER INDICATOR
When 12 volts is supplied to the unit this indicator will illuminate red and the unit
will be in stand-by mode. Press the POWER button (8) on the remote control (see
Fig. 2) to turn the unit on. The indicator (2) will turn from red to green.
3. REMOTE
This REMOTE jack (3) is connected to an external remote control receiver. Point
the remote control handset (see FIG.2) to the remote sensor of the receiver to
control the unit.
4 VIDEO/AUDIO IN
These three jacks (4) are connected to the DVD/VCD's VIDEO/AUDIO output
terminal. The Red jack is the AUDIO-RIGHT signal input; the White jack is the
AUDIO-LEFT signal output; the Yellow jack is the VIDEO signal input.
5 VIDEO/AUDIO OUT
These three jacks (5) are connected to the monitor's VIDEO input terminal and
AUDIO input terminal. The Red jack is the AUDIO-RIGHT signal output; the White
jack is the AUDIO-LEFT signal output; the Yellow jack is the VIDEO signal output.
6 DIVERSITY ANTENNA INPUT
There are four antenna input jacks (6) for antenna input.
7 12 VOLT OUTPUT
Use this as a power source for your video monitor.
REMOTE CONTROL (see FIG.2)
8 POWER
Press POWER button (8) to turn the unit ON or OFF.
9 TV/AV
Press the TV/AV button (9) to select between TV and AV mode.
10 AUTO
Press AUTO button (10) to enter into auto searching mode, then press CH+ button
(24) to start searching TV channels.
11 CH+
Press the CH+ button (11) to choose channel upward.
12 CH-
Press the CH- button (12) to choose channel downward.
25