Operations From Model-A Control Unit; Sirius Id [Esn] Display; Select Sirius Satellite Radio Mode; Selecting The Preset Band - Kenwood KTC-SR903 Instruction Manual

Sirius satellite radio tuner
Table of Contents

Advertisement

Operations from Model-A Control Unit

When you have the model-A control unit categorized by the
<Which is your control unit?> (page 5), follow the operation
instructions given below.

Sirius ID [ESN] display

You must have the Sirius ID number [ESN] for licensing with
Sirius Corp. Check the Sirius ID [ESN] of this unit as follows.
1
Select the Sirius Satellite Radio Mode
Press the [SRC] button.
Select the "SIRIUS" display.
2
Check the Sirius ID [ESN] of this unit
See the <Menu System> page of the instruction manual of
your control unit, and select the ESN menu item.
The Sirius ID [ESN] will be displayed.
Serial & Sirius ID [ESN]
It is especially important to retain the unit serial number and the
electronic Sirius Identification number for service activation and
potential future service changes.

Select Sirius Satellite Radio Mode

Listening to the satellite radio.
Press the [SRC] button.
Select the "SIRIUS" display.
• You need to subscribe to SIRIUS to receive the service by Sirius
Satellite Radio. Consult SIRIUS if "CALL 888-539 SIRIUS TO
SUBSCRIBE"/"CALL 888 539-SIRI" appears.
• It may take a little time to start receiving after you selected the
SIRIUS source.
• If the signal receiving fails, "Acquiring Signal"/"ACQUIRING
SIGNAL" appears.

Selecting the Preset Band

Press the [FM] button.
Each time the button is pressed the preset band switches
between the SR1, SR2, SR3 and SR4.

Tuning

Selecting the channel.
Press the [4] or [¢] button.

Channel Preset Memory

Putting the channel in the memory.
1
Select the preset band
Press the [FM] button.
2
Select the channel to put in the memory
Press the [4] or [¢] button.
3
Put the channel in the memory
Press the [1] — [6] button for at least 2 seconds.
The preset number display blinks 1 time.
On each band, 1 channel can be put in the memory on each [1]
— [6] button.
• Only the channel number is stored. Category information is not
stored.
• This function can be used only when the "Channel"/"CHANNEL"
has been selected in <Switching Seek Mode> (page 7).
— 6 —

Advertisement

Table of Contents
loading

Table of Contents