Squeegee Cleaning; Squeegee Blade Check And Replacement - Viper Fang15B Owner's Manual

Pay careful attention when charging WET batteries, as battery fluid could leak. Battery fluid is highly corrosive.
If fluid comes in contact with skin or eyes, rinse thoroughly with water and consult a physician.
1. Place charger and machine in a well ventilated area.
2. Turn machine off. (47)
3. Remove the recovery tank, (2) exposing battery compartment.
4. Plug the charging cable to the grounded wall outlet (100v~240v). Connect the charging cable to
the machine socket.
5. The charging light (30) indicates the batteries are charging. A green light indicates battery charging
is completed.
6. Upon the completion of charging, first unplug the charging cable from the wall outlet and then
disconnect from machine.
Replace the recovery tank.
7.
NOTE
For further information about the operation of the battery charger, (29) see the charger section.

SQUEEGEE CLEANING

NOTE
For optimal performance, the squeegee blades must be clean, dry and undamaged.
CAUTION !
It is advisable to wear protective gloves when cleaning the squeegee because there may be sharp debris.

SQUEEGEE BLADE CHECK AND REPLACEMENT

1. Take off the squeegee as shown in the previously.
2. Check the edges of the front & rear blades for cracks. If necessary replace with new blades.
3. Unscrew six the thumb nuts (37) to remove the blades.
4. Check the front & rear blades for cuts and tears. If damage is found, you can flip the blades once &
re-install. If already flipped, please replace with new blades.
5. Install the squeegee in the reverse order of removal.
7
USER M ANUAL