Connecting Wires To Terminals - Kenwood KDC-W6537U Instruction Manual

Connecting Wires to Terminals

USB connector (1m)
REMO.CONT
To Kenwood disc changer/
External optional accessory
Fuse (10A)
Wiring harness
(Accessory1)
TEL mute wire (Brown)
Power control/Motor antenna
control wire (Blue/White)
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
To USB device
Steering remote control (Light Blue/
Yellow) (KDC-W6537U only)
Rear left output /Sub Woofer left output (White)
Rear right output /Sub Woofer right output (Red)
If no connections are made, do not
let the wire come out from the tab.
Battery wire (Yellow)
Ignition wire (Red)
See next page
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
Connector B
Do not remove the cap when you do not use the USB
cable. The connector will cause the unit to malfunction
if it gets in touch with any metallic part of the vehicle.
AUX input (Stereo)
Use the mini-plug which is stereo type
and does not have any resistance.
FM/AM antenna input
Antenna Conversion Adaptor (ISO–JASO)
(Accessory3)
Front left output (White)
Front right output (Red)
To connect these leads, refer to the relevant
instruction manuals.
Connect to the terminal that is grounded when
MUTE
either the telephone rings or during conversation.
To connect the Kenwood navigation system, consult
your navigation manual.
Connect either to the power control terminal
P.CONT
when using the optional power amplifier, or to the
antenna control terminal in the vehicle.
ANT.CONT
Antenna Cord (ISO)
English
|
33