Specifications; Standard Accessories; Prior To Operation - Hitachi M 12SC Handling Instructions Manual

PRECAUTIONS ON USING ROUTER
1. Single-hand operation is unstable and dangerous.
Ensure that both handles are gripped firmly during
operation.
2. The bit is very hot immediately after operation.
Avoid bare hand contact with the bit for any
reason.

SPECIFICATIONS

Voltage
Power Input
Collet Chuck Capacity
No-load speed
Weight (without cord and

standard accessories)

STANDARD ACCESSORIES
(1) 8 mm Collet chuck ..................................................... 1
(2) Template guide .......................................................... 1
(3) Straight guide set ................................................ 1 set
1 Bar holder ........................................................... 1
2 Feed screw .......................................................... 1
3 Wing bolt ............................................................ 3
4 Guide bar ............................................................ 2
5 Straight guide ..................................................... 1
(4) 16 mm Wrench .......................................................... 1
(5) 23 mm Wrench .......................................................... 1
(6) Hex. bar wrench ........................................................ 1
(7) Hex. socket hd. bolt ................................................... 2
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES ... Sold separately
(1) Template Guide
A
16.5 mm
18.5 mm
25.5 mm
28.5 mm
(2) Chuck Sleeve
20 mm
Bottom of Sub base
B C
18 mm
20 mm
4.5 mm
27 mm
30 mm
230 V
900 W
12 mm / 8 mm
25000 / min
3.3 kg
D d
6 mm
12 mm
3 / 8"
(3) Dust collector set
Optional accessories are subject to change without notice.
APPLICATIONS
Woodworking jobs centered on grooving and
beveling.
For example, grooving beveling, cutting, copying,
engraving, shape cutting, combinations and others.

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
operating immediately, which could cause a serious
accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be kept
as short as practicable.
Shape of chuck sleeve
No groove
1 groove
2