Connecting Wires To Terminals - Kenwood KDC-MP625 Instruction Manual

Connecting Wires to Terminals

AUX right input (Red) (KDC-6025 only)/
Sub Woofer right output (Red) (KDC-X679 only)
AUX left input (White) (KDC-6025 only)/
Sub Woofer left output (White) (KDC-X679 only)
Sub Woofer left output (White) (KDC-MP625/MP6025 only)
Sub Woofer right output (Red) (KDC-MP625/MP6025 only)
KENWOOD disc changer input
To connect the Disc changer,
consult your Disc changer manual.
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect to
its power control terminal.
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna,
or to the power terminal for the booster amplifier of
the film-type antenna.
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
To "EXT.AMP.CONT. " terminal of the amplifier having
the external amp control function.
To front right speaker
Car fuse box
(Main fuse)
Battery
Rear left output (White) /
Rear right output (Red) /
Fuse (10A)
To car light control switch
White/Black
To front left speaker
White
Gray/Black
Gray
Green/Black
To rear left speaker
Green
Purple/Black
To rear right speaker
Purple
Ignition key switch
–
+
FM/AM antenna input
Power control wire (Blue/White)
P.CONT
Motor antenna control wire (Blue)
ANT.
CONT
TEL mute wire (Brown)
TEL MUTE
External amplifier control wire (Pink / Black)
(KDC-X679 only)
Dimmer control wire (Orange / White)
Car fuse box
ACC
Ground wire (Black) - (To car chassis)
Front left output (White)
Front right output (Red)
Wiring harness
(Accessory1)
FRONT • L
FRONT • R
REAR • L
REAR • R
Ignition wire (Red)
Battery wire (Yellow)
English
33
|