Frigidaire Refrigerator Use & Care Manual page 12

DOOR REMOVAL INSTRUCTIONS
Removing Freezer Drawer
1 Open freezer drawer.
2 Remove drawer screws on right and left sides (two screws on each side).
Remove Hex
Head Drawer
Screw
Remove
Hex Head Drawer
Screw

NOTE
Do not remove center screw from freezer
drawer. This is a factory adjustment.
Installing Freezer Drawer
1 With lower slides pulled out, hang drawer
onto slide brackets ensuring pins on each side
are fully inserted into slots on each side.
Assembly
Drawer Slides
Pin
Slot
2 Reinstall four drawer screws (two per side),
tighten down, and close drawer.
Install
crews
(2) Each
Side
12
Do Not Remove
Other Screws
Fully Extend
Cabinet
Remove Hex
Head Drawer
Remove
Hex Head Drawer
CAUTION
Drawer is heavy. Use caution when lifting.
3 Lift drawer up and out to remove.
3 Check gasket seal around top, bottom, and
sides of freezer drawer.
4 If gasket is not sealed, open drawer and
slightly loosen four drawer screws (two on
each side) to allow drawer to rotate.
5 Close drawer and recheck the seal on the
gasket (A). Open the drawer grabbing by
the sides in the center (B). Be careful not to
rotate the drawer.
Push
Against
Freezer
Drawer
A
6 Tighten four drawer screws.
7 Recheck gasket seal.
8 Install the toe grille by fitting into place.
Screw
Screw
Grab
Drawer
at Center
from Both
Sides
Then
Pull
Drawer
Out
B