Pc-To-Hub Communications Settings - HP J2415A Installation And Reference Manual

Installing and Using HP Stack Manager

PC-to-Hub Communications Settings

Use the Settings pull-down menu to configure the PC-to-hub
communications settings.
Direct Serial Communications
You can configure the PC-to-hub serial communication parameters by
selecting Communications... in the Settings menu.
The communications settings can be stored in an individual file for each
serial connection. See the HP Stack Manager online help for more
information.
Configuring Modems
If you are using a modem link, you can also set up the modems through the
Settings menu. Select Remote Modem... to configure and initialize the
modem that attaches to the hub, and then select Local Modem... to
configure the modem that stays attached to the PC running HP Stack
Manager.
Configuring Data Switching Devices
If you will be using HP Stack Manager through a data switching device (such
as a data switch, data terminal controller, PBX switch, or X.25 PAD), you
may need to configure the switching device. Use the terminal support
selection in the Settings menu.
Connecting and Disconnecting
The [Connect] button on HP Stack Manager's main screen causes the program
to establish a connection to the hub (or chain of hubs) using the current
PC-to-hub communication settings. The [Disconnect] button terminates the
communication connection between HP Stack Manager and the hub (or
chain of hubs).
2-6