White Outdoor LT-542KH Operator's Manual page 10

ATTACHING THE SEAT
Seat styles vary by tractor model and there are two
different styles available:
• Quick Adjustment
• Knob Adjustment
Refer to Figure 3 and Figure 4 to identify your tractor's
seat style and follow applicable instructions.
NOTE:
For shipping reasons, seats are either
fastened to the tractor seat's pivot bracket with a plastic
tie, or mounted backward to the pivot bracket. In either
case, free the seat from its shipping position and
remove the two hex screws (or knobs, on models so
equipped) from the bottom of seat before proceeding
with applicable instructions below
Quick Adjustment Seat
NOTE:
If your seat was shipped mounted backwards
on the seat pivot bracket, pull out the tab found on the
seat stop and hold it open while sliding the seat off the
seat pivot bracket. See Figure 3.
1. Line up the plastic seat spacers with the slots in
seat pivot bracket.
2. Slide seat in until front seat spacer engages the
seat stop.See Figure 3.
WARNING:
make sure the seat is engaged in the seat
stop, stand behind the machine and pull back
on seat until fully engaged into stop
Knob Adjustment Seat
1. Position the shoulder screws (found on the base of
the seat) inside the slot openings in the seat pivot
bracket. See Figure 4.
2. Slide the seat slightly rearward in the seat pivot
bracket, lining up the rear slots in the pivot bracket
with the remaining two holes in the seat's base.
3. Select desired position for the seat, and secure with
the two knobs removed earlier. See Figure 4.
Quick Adjustment
Seat Stop
Tab
Pivot Bracket
Figure 3
.
Before operating this machine,
.
Knob Adjustment
Knobs
Shoulder Screws
Opening in Slot
Pivot Bracket
GAS AND OIL FILL-UP
The gasoline tank is located under the hood and has a
capacity of either two or three gallons. Do not overfill.
WARNING:
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Never fuel machine indoors or while the
engine is
cigarettes, cigars, pipes, and other sources of
ignition.
Service the engine with gasoline and oil as
instructed in the separate engine manual packed
with your tractor. Read instructions carefully.
IMPORTANT:
Your tractor is shipped with oil;
however, you MUST check the oil level before
operating. Be careful not to overfill. Overfilling with oil
may cause the engine to smoke. This will result in poor
engine performance and could cause permanent
engine damage.
SHIPPING BRACE REMOVAL
WARNING:
engine is off, set the parking brake and
remove the ignition key before removing the
shipping brace
• Locate the shipping brace and warning tag found
on the right side of the cutting deck. See Figure 5.
• While holding the discharge chute with your left
hand, remove the shipping brace with your right
hand by grasping it between your thumb and index
finger and rotating it clockwise.
WARNING:
packaging purposes only, must be removed
and discarded before operating your riding
mower.
10
Figure 4
Use extreme care when
hot or running. Extinguish
Make sure the riding mower's
.
The shipping brace, used for