Check List Of Step-By-Step Guides To Install - Kenmore GENIUS II 625.34867 Owner's Manual

SECTION 1 WATER SOFTENER START-UP
! !
lB. CHECK LIST OF ALL STEP-BY-STEP GUIDES TO INSTALL
To be sure you have done all the steps to install the
softener, read the following list. Refer to the
Installation Manual, part no. 7183613, for step-by-step
guides.
Page numbers referred to are in the Insta/Iation
Manua/unless otherwise noted.
€' Is the house water flow going INTO the softener
valve INLET?.Trace piping to be sure. See pages 10
and 11.
I/ Is the plumbing bypass valve (or 3 valves) set for
SERVICE? See FIG. 12, page 20 of this manual.
v' Is the valve drain hose connected the right way,
and without sharp bends or kinks that could stop
or reduce water flow? See page 16.
Page numbers referred to are in the Insta//ation
Manua/unless otherwise noted.
v' Is the softener power cable connected to the trans-
former? Is the transformer plugged into an inside,
120V-60Hz electrical outlet? See page 20 in the
installation manual, and the wiring schematic on
page 21 of this manual.
v' Be sure to restart the water heater. See page 20.
-".t::
plastic
_ VALVE
INLET
Jt/;
3-valve _- _ !
5