Toshiba 32L3300 Series Owner's Manual page 25

NOTE:
This feature is not available when Auto Format is set
to Off .
Panel Lock
Panel Lock disables the buttons on the TV. All
buttons on the remote control can still be used.
1
From the PREFERENCES menu, press  or  to
select Panel Lock.
2
Press  or  to select On or Off .
NOTE:
When Panel Lock is On, a reminder will appear when
the keys on the TV are touched. If the standby key is
touched, the TV will switch off and can only be brought
out of standby by using the remote control.
Setting the Automatic Power Down
The TV will automatically turn itself off (standby)
after approximately 4 hours, if you do not operate
the control buttons on the remote control or on the
TV control panel.
1
From the PREFERENCES menu, press  or 
until Energy Saving Settings is selected, and
then press OK.
2
Press  or  to select Automatic Power
Down, press  or  to select On or Off , and
then press EXIT.
NOTE:
1 minute before switching to standby, a warning
message will appear.
Setting the No Signal Power Down
The TV will automatically turn itself off after 15
minutes when no signal is detected. You can change
the setting to Off for the following purposes:
• Low signal strength of analog channel (no signal
detection).
• Only Audio L/R is connected to an external
input in order to listen to music through the TV
speakers.
1
From the Energy Saving Settings menu, press
OK.
2
Press  or  to select No Signal Power Down
and press OK.
3
Press  or  to select the item you want to
change and press  or  to select On or Off .
Using the TV's features
NOTE:
• Default setting is all On.
• A warning message will appear 1 minute before
turning off .
Viewing the Software Licences
The licences for the software used in this TV are
available for viewing on screen.
1
From the SETUP menu, press  or  to select
Software Licences.
2
Press OK.
A screen will appear displaying all of the
licencing information required for the TV's
software.
Confi rming software version
1
From the SETUP menu, press  or  to select
System Information and then press OK.
2
Press OK to display the software version.
NOTE:
The software version displayed is just for the
illustration.
Resetting the TV
Reset TV will reset all TV settings, including stored
channels, to their original factory values.
1
From the SETUP menu, press  or  to select
Reset TV.
SETUP
Auto Tuning
Manual Tuning
Quick Setup
Location
Software Upgrade
Software Licences
System Information
Reset TV
2
Press OK to select.
A screen will appear warning that all settings
will be lost. Select Yes, and then press OK to
continue.
When the set powers back on, the fi rst time
screen will appear (- page 11). Press OK
to continue, and proceed to the Auto Tuning
menu.
If Network PIN code has been set, the PIN input
screen will appear (- page 39).
Home
25