Table of Contents
Advertisement
water supply
fitting
3/8" black
tubing
NOTE: Tubing lengths
should
allow for the removal
of the assembly
from the hanger washers
for servic-
ing. If tubing lengths
are shortened
for nearer
appearance,
it may be necessary
to keep the assem-
bly on the hanger washers
for service.
NOTE: Codes in the state of Massachusetts
require
installation
by a licensed
plumber
and do not permit
the use of saddle
valves. If you live in the state of
Massachusetts,
review plumbing
code 248-CMR of
the Commonwealth
of Massachusetts
before pro-
ceeding with the installation.
cX9
i IOT
COLD
/
sink p-trap
NOTE: Tube colors match
Collet colors
3/8" yellow tubing
tubing
onnector
Tube Connections
CONNECT
YELLOW
TUBE TO STORAGE
TANK
1. Locate the yellow tube. One end is attached
to the Reverse
Osmosis
filter assembly.
2. Run the other end of the yellow tube to the fitting on top of
the storage tank. See Figure 21.
3. Cut tube square and to length. See Figure 17.
4. Do not connect at this time. This will occur in the sanitizing
step.
Figure
21
CONNECT
BLUE TUBE
TO REVERSE
OSMOSIS
ASSEMBLY
1. Locate the blue tube. One end is attached
to the faucet.
2. Run the other end of the 3/8" blue tube to the blue collet on
the right side of the Reverse Osmosis
filter assembly.
3. Cut tube square and to length. See Figure 17.
4. Insert all the way into the fitting. See Figures
18A & 18B.
5. Pull on the tube to be sure it's held firmly in the fitting.
CONNECT
GREEN
TUBE
TO COLD
WATER
SUPPLY
PIPE
1. Run one end of the 1/4" green tube to the fitting on the water
supply pipe. See Figure 21.
2. Cut tube square and to length. See Figure 17.
3. Connect
to saddle valve. This is a compression
fitting.
4. Run the other end of the green tube to green collet to the fit-
ting on the left side of the Reverse Osmosis
filter assembly.
5. Cut tube square and to length. See Figure 17.
6. Insert all the way into the fitting. See Figures 18A & 18B.
7. Pull on the tube to be sure it is held firmly in the fitting.
CONNECT
RED TUBE TO REVERSE OSMOSIS
FAUCET
The red tube cormection was completed in the faucet assembly
steps.
CONNECT
BLACK
TUBE
FROM
REVERSE
OSMOSIS
FAUCET
TO DRAIN
ADAPTER
1. Locate the 30" length of 3/8" black tube. One end is attached
to the faucet. Figure 21.
2. The other end needs to be attached
to the black collet on the
sink drain adapter.
3. Cut this tube as needed
to route in as straight
of a run as
possible,
without
loops, dips, low spots or kinks.
4. Cut the end of the tube square.
See Figure 17.
5. Insert all the way into the fitting. See Figures 18A & 18B.
6. Pull on the tube to be sure it is held firmly in the fitting.
Questions?
Call The Kenmore
Water Line 1-800-426-9345
or visit KenmoreWater.com
15
Hide quick links:
Advertisement
Table of Contents
