Display Assembly - HP Compaq Presario F500 Maintenance And Service Manual

Display assembly

Description
15.4-inch, WXGA, BrightView display assembly (includes wireless antenna transceivers
and cables)
Before removing the display assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power cord.
4.
Remove the battery (see
5.
Remove the memory module compartment cover (see
6.
Disconnect the wireless antenna cables from the WLAN module (see
7.
Remove the following components:
a.
Switch cover (see
b.
Keyboard (see
Remove the display assembly:
1.
Disconnect the display cable (1) from the system board.
2.
Remove the wireless antenna cables (2) from the clips built into the top cover.
CAUTION:
support the display assembly can result in damage to the display assembly and other computer
components.
3.
Remove the four Phillips PM2.5×7.0 screws (1) that secure the display assembly to the computer.
Battery on page 28).
Switch cover on page
Keyboard on page 39)
Support the display assembly when removing the following screws. Failure to
Memory module on page
37)
Component replacement procedures
Spare part number
442876-001
31).
WLAN module on page 34).
43