Troubleshooting - Porter-Cable Porta-Plane 126 Instruction Manual

ADJUSTING THE CUTTER-ADJUSTING LEVER TENSION
Each time the blade is sharpened, the plane must be reset to "0" so that the
depth adjusting lever can accurately measure the depth of cut. If the cutter
adjusting lever is too tight or too loose, adjust it immediately to the proper
tension.
DISCONNECT THE TOOL FROM THE POWER SOURCE!
Remove the five handle-cover
retaining screws on the right side
of the handle. Lift the handle cover
to reach the cutter adjusting lever
nut (A) Fig. 11. Tighten or loosen
this nut until the lever's tension
is sufficient to hold it securely in
place. Attach the handle cover.
For assistance with your tool, visit our website at www.porter-cable.com for a
list of service centers, or call the Porter-Cable Customer Care Center at
5175.
Do not pinch the wires!

TROUBLESHOOTING

13
A
Fig. 11
(888) 848-