Removing The Power Supply Unit; Removing The Motherboard - Packard Bell iDesign Series Disassembly Manual

section Removing the Drive Bracket), then:
1. Disconnect the switch/USB assembly power cables from
the motherboard.
2. Remove both screws holding the switch/USB assembly to
the chassis.
Fig. 16: Removing the switch/USB assembly
3. Gently pull the cables through the orifice in the chassis.

Removing the Power Supply Unit

To remove the power supply unit, first open the chassis (see
section Opening the Chassis), then follow the steps below:
1. Lay the chassis down on one side.
2. Disconnect the power supply cables from all peripherals
and the motherboard.
3. Remove the screws at the back of the chassis.
Fig. 17: Removing the screws of the power supply unit
4. Carefully lift the power supply out of the chassis.

Removing the Motherboard

To remove the motherboard, open the chassis (see section
Opening the Chassis), remove the front bezel (see section
Removing the Front Bezel), remove the drive bracket
containing the DVD/CD-ROM and floppy disk drive (see the
section Removing the Drive Bracket), remove all add-on cards
f th i l t ( ti R
iDesign Disassembly Manual - 9
i Add O C d )