Assembly Instructions - Kärcher HDS 4.0/32 Pe Cage - 1.575-615.0 Operator's Manual

High Pressure
STEP 1: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
STEP 4: Connect the high pressure
hose to the pump discharge fitting.
Push coupler collar forward until
secure.
Due to Federal Regulations concerning shipment of
corrosive chemicals, batteries are not shipped with
this machine.
DANGER/ POISON
SHIELD
EYES
NO
EXPLOSIVE
SPARKS
GASES
CAN CAUSE
FLAMES
SMOKING
BLINDNESS OR INJURY
KEEP OUT OF THE REACH OF CHILDREN. DO NOT TIP. KEEP VENT CAPS TIGHT AND LEVEL.
Local purchase of battery will be the responsibility of
the owner. Automotive type 12 Volt Group 24 battery
is recommended for placement within the weather
resistant box. Follow safety and installation instruc-
tions furnished with the battery.
8

ASSEMBLY INSTRUCTIONS

High Pressure
Spray
Gun
Wand
Hose
STEP 2: Remove Wand end and
first place the O-ring followed by
the high pressure nozzle as shown.
Replace end of wand.
22mm
Coupler
STEP 5: Connect garden hose to
the cold water source.
BATTERY INSTALLATION
FLUSH EYES
IMMEDIATELY
WITH WATER
SULFURIC GET
MEDICAL
ACID
HELP
CAN CAUSE
BLINDNESS OR
FAST
SEVERE BURNS
9.800-103.0 - B • Karcher HDS 615-617
Nozzle
O-Ring
Red Cable is attached to battery (+) positive termi-
nal, black cable is connected to battery (-) negative
terminal.
Black - Negative
Terminal
Red + Positive
Terminal
STEP 3: Remove shipping cap and
install oil dipstick. Check pump oil
level by using dipstick or observe
oil level in oil window (if equipped).
Use 30 wt. non detergent oil.
Water
Inlet
Garden
Hose
STEP 6: Check inlet filters, re-
move debris, then connect the
garden hose to pump water inlet.
CAUTION: Do not run the pump
without water or pump damage
will result.
98001030-8