Battery Recharge - Panasonic KX-TG6811SA Operating Instructions Manual

Programmable settings
Problem
The display is in a
language I cannot read.
I cannot activate the eco
mode.
I cannot register a handset
to a base unit.

Battery recharge

Problem
The handset beeps and/or
flashes.
I fully charged the
batteries, but
– still flashes or
– the operating time
seems to be shorter.
Making/answering calls, intercom
Problem
is displayed.
Noise is heard, sound cuts
in and out.
The handset does not ring. R The ringer volume is turned off. Adjust ringer volume (page 16,
The base unit does not
ring.
TG68xxSA(en)_0619_ver011.pdf
Cause/solution
R Change the display language (page 12).
R You cannot set eco mode when you set the repeater mode
"On". If required, set the repeater mode to "Off" (page 29).
R You entered the wrong PIN. If you forget your PIN, contact an
authorised service centre.
Cause/solution
R Battery charge is low. Fully charge the batteries (page 9).
R Clean the battery ends (
a dry cloth and charge again.
R It is time to replace the batteries (page 8).
Cause/solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 47).
R Activating one touch eco mode reduces the range of the base
unit in standby mode. If required, turn eco mode off (page 14).
R You are using the handset or base unit in an area with high
electrical interference. Re-position the base unit and use the
handset away from sources of interference.
R Move closer to the base unit.
R If you use a DSL/ADSL service, we recommend connecting a
DSL/ADSL filter between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for details.
24).
R Night mode is turned on. Turn it off (page 27).
R The ringer volume is turned off. Adjust ringer volume (page 24).
45
Useful Information
, ) and the charge contacts with
2013/06/19 17:43:18
45