Table of Contents
Advertisement
The oil drain hose may be routed in the opposite
direction as shown in figure.
4.4
CHANGING THE ENGINE
AIR CLEANER
4.4.1
14, 17 & 20KW GENERATORS
See "The Generator" section for the location of the air cleaner. Use
the following procedures (Figure 4.5):
1.
Lift the roof and remove the door.
2.
Turn the two screws counterclockwise to loosen.
3.
Remove the cover and air filter.
Figure 4.5 — 14, 17 & 20kW
Engine Air Cleaner
Screw
4.
Wipe away dust or debris from inside of the air box and
around edges.
5.
Install the new air cleaner into the air box.
6.
Install the cover. Turn the two cover screws clockwise to
tighten.
See the Service Schedule section for air cleaner maintenance. See
the Specifications section for air filter replacement part number.
4.4.2
10KW GENERATORS
See "The Generator" section for the location of the air cleaner. Use
the following procedure (Figure 4.6):
1.
Lift the roof and remove the door.
2.
Turn the worm gear clamp screw counterclockwise to loos-
en.
3.
Pull the old filter off the divider panel hub.
4.
Wipe away dust or debris from the panel hub.
5.
Install the new air cleaner onto the hub.
24
Section 4 — Maintenance
Air-cooled Generators
NOTE:
Cover
Filter
6.
Turn the worm gear clamp screw clockwise to tighten.
7.
Replace door and roof.
Figure 4.6 — 10kW Engine Air Cleaner
Air Filter
4.4.3
8KW GENERATOR
See "The Generator" section to locate the air box. Use the following
procedures to replace the dirty air filter within the air box (Figure
4.7).
1.
Lift the roof and remove the door.
2.
Push back on the latch of the yellow air filter access door to
swing open.
3.
Pull out the old air filter and discard appropriately.
4.
Install the new filter, open end first into the air box.
5.
Swing the yellow door shut and snap to close.
6.
Replace door and close roof securely.
Figure 4.7 — 8kW Engine Air Cleaner Location
Air Cleaner
Cover
Advertisement
Table of Contents
