Connecting To An Antenna; Connecting To An Antenna Via A Vcr - Sharp SX68NF8 Operation Manual

Connections

Connecting to an antenna

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of
the types of connections that are used for coaxial and feeder cables.

Connecting to an antenna via a VCR

You can also connect the TV set to the tuner on a VCR using the connection shown below.
To antenna in
terminal
• When using the RF terminal connection, set the TV to channel zero to make initial adjustments for the VCR.
• Turn off the power on the TV set and the VCR being connected before making the above connections.
Be sure the cord plugs are fully inserted in the connection terminals.
• See the operation manual of your VCR for connection details.
E 31
SX68NF8(26-32)
If your outdoor antenna uses a 75-ohm coaxial cable with a standard
DIN45325 plug (IEC 169-2), plug it into the antenna jack at the rear of
the set.
If your outdoor antenna uses a 300-ohm twin-lead flat feeder, connect a
300-ohm to 75-ohm impedance converter and plug it into the antenna
jack at the rear of the set.
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable) (not supplied)
300-ohm twin-lead 75-ohm impedance
flat feeder converter
(not supplied) (not supplied)
VCR
31
P r i n t e l l i g e n c e ( M ) S d n . B h d
TV
TV
To RF out terminal
7/11/02, 2:05 PM
D i m e n s i o n : 1 7 6 x 2 5 0 m m
ANT/
CABLE
75Ω
OUT AV-1 IN AV-2 IN COMPONENT
S-VIDEO
(AV-1 IN) Y
L P
(C ) B B
(MONO)
P R
R (C ) R
ANT/
CABLE
75Ω
Antenna in
ANT/
CABLE
75Ω OUT AV-1 IN AV-2 IN
COMPONENT
S-VIDEO
(AV-1 IN) Y
L P
(C B B )
(MONO)
R P R
(C ) R
ANT/
CABLE
75Ω
Antenna in