Samsung SNP-5430 User Manual page 108

setup screen
• Enable SNMP Trap : SNMP trap is used to send important events and conditions
to the Admin.
- Community : Enter the trap community name to receive messages.
- IP address : Enter the IP address to which messages will be sent.
- Authentication failure : It specifies whether an event shall be generated when the
community information is invalid.
- Network connection : It specifies whether an event shall be generated when the
network disconnection is restored.
• Enable SNMP v3 : SNMP version 3 will be active.
- Password : Specify the default password for SNMP version 3. The default
password is <admin4321>.
The default password can be exposed to a hacking thread so it is recommended to change the
`
password after installing the product.
Note that the security and other related issues caused by the unchanged password shall be
responsible for the user.
Password should be longer than 8 characters, no more than 16 characters.
`
4. When done, click [apply (
SNMP v3 is only able to be set when the secure connection mode is HTTPS.
`
J
Refer to "SSL". (page 105)
If you don't use SNMP v3, there may be a security issue.
`
auto ip configure
You can set the IP available for access and camera searching automatically.
1. From the Setup menu, select the
<network (
2. Click <auto ip configure>.
3. Set the <Link-Local ipv4 address>.
An additional IP address may be
assigned to assess the camera from
the Link-Local network.
• Auto configure : It specifies Able
or Disable for the Link-Local IPv4
address.
• IP address : Display the assigned IP
address.
• Subnet mask : Display the subnet mask of the assigned IP.
108_ setup screen
)].
)> tab.