Advertisement
Attaching
the lens (Fig. 3)
^
* After taking pictures, or when the camera is not going to be
l/ Hold the main body section of the lens (€), match the indices on
used for a long time after taking pictures, turn power off so that
the lens (red dot) with the lens indices on the camera @. press
the shutter will not be released accidentally.
the lens on gently and then turn clockwise until you hear a click.
* When power is turned ofT only the battery mark will be lit in the
Then turn until the lens stops.
display panel. Red mark can no longer be seen.
* Before attaching a lens, remove the lens's rear cap and the
g l m e r a ' s b o d y c a p .
O p e r a t i o n s
d u r i n g
c o n s e c u t i v e
p h o t o g r a p h y
* If the lens will not go on the camera, or if the index is out of line
(Fiq. 6)
and the lens is on, the lens cannot lock in place.
7 itrnthe main switch lever so that the index is on ,,C". press and
lemovins a rens (Fig. 4)
l:il:,i",T:.,fi!"ff"tTt:,xPo;;ffiiJrtJ.'res
consecutiverv'
f
{old the lens by the main body section, press the removal button
* Maximum piciure-frahe speeil is three frames per second.
@ on rhe camera. and turn the lens counterclockwise until it
However, frime speed will .hung" depending on shutter speed,
stgpq. Then remove it by pulling it forward.
sensitivity of the film being used and batterylevel.
* The lens will come off when the lens and camera body indices
are matched.
4. Display
Panel
(Fig. 7)
* After removing.the lens,- don't forget to protect ,!:
:-"-q:: ll9
The diagram shows all crystil displays in the ..on,, stare.
the lens by attaching the lens cap and the rear cap ro the lens and
@,
-Suti"r'
power Symboi
the body cap to the camera.
6 Fii;
counrer
3. Operating the main switch lever
Liquid Grystal Display
operating the main switch lever @ turns the .o..t1
!9y,"_t
o.l
1lq
rrtt.'.u-".u
uses rhe liquid crysral in the Display panel.
o{31d allows switching-to consecutive photography (Fig 6) and
* iri" r-co display daikens uihigh t"-p..atures, and the responss
selfLimer photography (Fig. 34).
is slower at lbw'temperatures.
* Operate_ the camera after turning the lever stopping at the position
* ine I_Cp returns totorrect operating characteristics at normal
where the click sound is heard.
temperatures.
Jurning Powgr,gn an! off
(Fig. 5)
.L: _..d,, , -
5. Using the viewfinder (Fig. 8)
v Turn rnuin switch Iever @ se t the index to position "S'^(one-
ir'rJ,ii.u,o,
insicle rhc rinder lights up when power goes oN and
frame photography) and camera power will be on. Normat
;h;;'i;.
shu*er retease .,utton ffii
fi#;';#;;'rf;""1"'oy
oo*n
operation of the camera is in this position.
* rhe red mark @ can be seen in p6wer gN .Iut".,..,
morL in ,h- ::JHff:n?ljfll[;1x..tiTlil"g,:'.#t]j,3ffij:i,:?:1,,1:
* when power is on' the film counter and the battery mark in the
i;;i;rr
inside the finder will go off. when the shutter button is
_ display panel @ will be lighted
..r;.rr., n--..^,r ;r.,,:, -- r:^r^+
i z iid;;iff;;;#;;;;'"r
ro the position shown
'
partiallv pressed' it will re-light'
!
the.power witl be off. Stop the lever *n"r irt?r'i; ff3tlTl
* The cliagram shows all da?a in lighted state'
I
P o s t t t o n '
5 3
I
i
ff
rf
Advertisement
