3M 6000 Series User Instructions page 8

5N11
5P71 07194
7093
7093C 37173
****AAD part numbers are catalog numbers only. NIOSH approved as OH&ESD part numbers
1
3M recommended for relief against nuisance levels of acid gases or organic vapors. Nuisance level refers to
concentrations not exceeding OSHA PEL or applicable government occupational exposure limits, whichever
is lower. Do not use for respiratory protection against acid gases or organic vapors.
2
3M recommended for ozone protection up to 10 times the OSHA PEL or applicable government
occupational exposure limits, whichever is lower. Note: Not NIOSH approved for use against ozone.
3M particulate filters must be immediately changed when an increase in breathing resistance is noticed.
ASSEMBLY INSTRUCTIONS
Note: Make certain 3M™ Inhalation Port Gaskets 6895 are in place on the facepiece bayonet connectors
before installing filters, cartridges or breathing tubes.
3M™ 6000 Series Cartridge Assembly
1. Align cartridge notch with facepiece mark, as shown, and push together. (Fig. 1)
2. Turn cartridge clockwise to stop (1/4 turn). (Fig. 2)
3M™ 5N11 and 5P71 Filter Assembly
1. Place filter into 501 retainer so printed side of filter faces the cartridge. (Fig. 3)
2. Press cartridge into filter retainer. It should snap securely into filter retainer. When correctly installed,
filter should completely cover face of cartridge.
3. To replace filter, remove retainer by lifting on tab.
3M™ 2000 Series and 7093/7093C Filter Assembly
1. Align opening of filter with filter attachment on facepiece.
2. Turn filter clockwise until it is firmly seated and cannot be further turned.
3. Repeat for second filter.
3M™ Filter Adapter 502 Assembly and Filter Attachment
1. Align adapter over cartridge. Engage front snap by squeezing front of cartridge and adapter together,
placing thumbs of both hands over top of adapter and fingers along bottom sides of cartridge. (Fig. 4)
2. Engage back snap by squeezing back side of cartridge and adapter together using the same hand
positions. (Fig. 5) An audible click should be heard as each snap is engaged.
3. Place filter onto the filter holder so that filter comes into even contact with gasket. Twist clockwise a
quarter turn until it is firmly seated and filter cannot be turned further. Repeat for second filter.
Particulate Filter, N95
Particulate Filter, P95
Particulate Filter, P100
Particulate Filter, P100, hydrogen fluoride with nuisance level
organic vapor/acid gas relief
8
1