Download Print this page

Stanley FUSION PELLET STOVE Operating & Installation Manual page 16

Table of Contents

PROBLEM / CAUSE

Problem

Causes

Solutions

Problem

Cause

Solution

If the problem cannot be resolved, please contact the Stanley Service Department.

SOLUTION

Pellet loader blocked

Poor quality pellets, sawdust inclued accidentally or pellet stuck and obstructing the

feeder slide to the burner, possibly causing the loading auger to become blocked.

The problem can often be resolved without calling technical support, simply by insert-

ing a flexible steel rod inside the pellet loading tube once the stove is off and has

cooled. In this way, the blocked pellet can be made to fall into the burn pot, thus

unblocking the auger. This operation is carried out with the stove off and the power

supply plug disconnected.

While the stove is in operation, the pellet loading indicator light comes on, but no pel-

lets fall into the burn pot.

* Air exchanger ventilator dirty

* Air exchanger ventilator broken

* Stove overheating and safety thermostat was activated

* Flue obstructed or draught diverter grill clogged

* Call technical support service

* Clean the whole flue - remove draught diverter and grill

Table of Contents