Advertisement
Grill
Lighting
Instructions
1. Before
each
use, check
all hoses for cracks,
nicks,
cuts, burns
or abrasions.
If a hose
is damaged
in any
way,
do not use your
grill before
replacing
the hose
with
an authorized
part from the Parts
List. Also
make
sure
all gas supply
connections
are securely
tight-
ened.
2. Familiarize
yourself
with the safety and Use
and Care
instructions
in this manual.
Do not smoke
while
lighting
grill or checking
gas
supply
connections.
3. Be sure the LP Gas tank is filled.
4. Open
the Grill Lid.
5. Check
that the end of each
Burner
Tube
is properly
located
over each
Valve
Orifice.
Failure
to
replace
a faulty
hose,
secure
gas
supply
connections
or
to open
the
Lid
before
proceeding
to
the
Lighting
Procedures
could
result
in a fire
or
explosion
that
could
cause
serious
bodily
injury,
death,
or
property
damage.
6. Set Control
Knobs
to OFF and open
the LP Gas tank
valve SLOWLY
1/4 of a turn.
I
OFF
Open
LP
Gas_
_-
7. Push and turn the Left Control
Knob
to HIGH.
HIGH
MED
OFF _
LOW
8. Immediately
press
the
Electric
Ignitor
for
3-4
seconds
to
light
the
Burner.
If ignition
does
not
occur
in 5 seconds,
turn
the
burner
Control
Knob(s)
and
gas
source
OFF
and
conduct
a leak test
of ALL
gas
connections
and
gas
sources
as
explained
in
the
Use
and
Care
section
of this
manual.
If no
leaks
are
detected,
wait
5 minutes
for
any
gas
to clear
and
repeat
the
lighting
procedure.
Side
Burner
Lighting
Instructions
1. Follow steps 1 through 3 of the Grill Lighting
Instructions.
2. Open
Side
Burner
Lid.
3. Set Control
Knob
to OFF and open
the LP Gas tank
valve
1/4 ~ 1/2 turn SLOWLY.
Push
and turn the Control
Knob
on Side
Burner
to
HIGH.
Press the Electric
ignitor
for 3-4 seconds
to light the
Burner.
5. If the burner
does not light, turn the knob to OFF.
Wait
5 minutes,
then
retry or light by using lighting
stick with a match.
If ignition
does
not occur,
turn
the burner
Control
Knob and gas source
OFF and conduct
a leak test of
ALL
gas connections
and fuel
sources.
If no leaks
are detected,
wait 5 minutes
for any gas to clear and
repeat
the lighting
procedure.
Manually Lighting Your Grill By Paper Match
To light your
gas grill by match,
insert a match
into the
Lighting
Stick and follow
steps
1 through
6 of the Grill
Lighting
Instructions.
Then,
light the match
and
place
Lighting
Stick through
the Lighting
Hole on the left side
of the grill as shown
below.
Turn
the nearest
Control
Knob
to the HIGH
setting
to release
gas.
The Burner
should
light
immediately.
LIGHTING
I
HOLE
LIGHTING
/_
STICK
\
MATCH
PRESS
9. After the Burner
is lit, turn the tank valve SLOWLY
one more
1/4 of a turn for 1/2 of one complete
turn.
Never
lean
over
the
grill
cooking
area
while
lighting
your
gas
grill.
Keep
your
face
and
body
a safe
distance
(at
least
18
inches)
from
the
Lighting
Hole
or
Burners
when
lighting
your
grill
by match.
Once
Left Burner
is lit, the right adjacent
Burner(s)
can be lit by turning
its Control
Knob
to HIGH
in
sequence
from
left to right.
2O
Advertisement
