Advertisement
6. From underside o fleftsideshelf, r emove 2 screws and
lockwashers to assembly t owelrackandbezels Hang the
twotrashclips(R)totheright s ideburner s helfedge(Fig.6).
7. Remove ( 3) 1/4x 3/8"Phillips head screws and(3) 1/4"
lockwashers onsideshelffrontpanel. T henattach front
panel t osideshelfusing thesame3 screws andlock
washers (Fig.7).
8.Attach leftsideshelfin samemanner a sdescribed f or
rightsideshelfin steps 2 and3.
InstallingIgniter
Module
Locate igniter module at right side of cabinet. Remove silver
battery cap and hexagon plastic nut from battery box. Insert
threaded stem of battery box through hole in side burner
control panel as shown (Fig. 8). Tighten it to panel using
hexagon plastic nut. Replace battery cap.
Installing Side Burner Valve
1. Locate side burner valve in right side of grill cabinet.
Remove 2 screws and washers from valve. Insert valve
stem through hole in front panel. Place side burner control
knob bezel over valve stem, and attach bezel and valve
stem to front panel with same 2 screws and washers (Fig. 9).
2. Remove rubber decorative band from control knob to
reveal set screw access hole. Push control knob over valve
stem. Secure knob to stem by using included 5/64" hex
wrench to tighten set screw (Fig. 10).
3. Plug side burner igniter wire into igniter module (Fig.11).
4.Ensure small igniter wires into igniter module (Fig. 12).
5. Assembly 2pcs tower racks to side shelf control panel
(Fig.13).
Figure 9
Figure 10
Figure 11
5/64" hex wrench
I When you have finished assembling grill, make
sure that all screws and nuts are tight and secure.
Figure 6
Figure 7
Figure 12
Figure 8
8
Advertisement
