Advertisement
5. Using (3) 5/32 x 1/2" screws and (3) 1/2" lock
washers, securely attach side burner shelf to grill head.
Fully tighten two screws from previous step. Secure
side burner control panel to main control panel with
screw removed in step 2. (Fig. 11 )
6. Repeat steps 2 through 5 to install side shelf.
Installing Side Burner Valve
1. Remove the two screws attaching side burner to
underside of side burner shelf to make room to install
side burner valve. See Figure 12 A inset.
2. Remove two screws and washers from side burner
control valve face. Insert side burner valve control
stem through hole in side burner control panel. See
Figure 12 B.
3. Place side burner control knob bezel over side
burner valve control stem. Secure bezel to control and
valve with 2 screws removed in step 2. Push control
knob onto valve control stem. See Figure 13.
4. Insert valve orifice tip into burner tube as shown in
Fig. 12. Reattach burner to underside of side burner
shelf with screws removed in step 1.
5. Plug ignition wire into igniter wire electrode on
underside of burner(Fig. 14).
Figure 12
A
B
Figure 13
I When you have finished assembling grill, make
sure that all screws and nuts are tight and secure.
Installing
Battery
1.Unscrew the ignition battery cap. (Found at far left of
control panel).
2.Install battery into ignition box with positive terminal
facing outward.
3.Replace the ignition battery cap after the battery has
been installed. (Fig. 15)
3pcs: ¼ X ½"
1pc: ¼ X ½"
Figure 14
Figure 11
/
1pc: 5/32 X ½"
10
Figure 15
/
/
Advertisement
