Wolf CT15I Installation Manual page 6

Induction Cooktop Specifications
Electrical Requirements
Wolf induction cooktops have a 4' (1.2 m) flexible conduit
and require a separate, grounded 3-wire electrical supply
with its own circuit breaker. Locate the electrical supply
within the shaded area shown in the installation illustration
for your specific model on the following pages.
MODEL CT15I/S
• Power supply: 240/208 V AC, 60 Hz, 20 amp service.
• Max connected load: 3.6 kW at 240 V, 3.1 kW at 208 V.
MODELS CT30I/S AND CT30IU
• Power supply: 240/208 V AC, 60 Hz, 40 amp service.
• Max connected load: 7.2 kW at 240 V, 6.3 kW at 208 V.
MODELS CT36I/S AND CT36IU
• Power supply: 240/208 V AC, 60 Hz, 50 amp service.
• Max connected load: 10.2 kW at 240 V, 8.9 kW at 208 V.
IMPORTANT NOTE: You must follow all National Electrical
Code regulations. In addition, be aware of local codes and
ordinances when installing your service.
IMPORTANT NOTE: Performance may be compromised if
the electrical supply is less than 240 volts.
The cooktop is provided with a terminal box and conduit
consisting of two insulated hot lead conductors and one
insulated ground conductor. Refer to the illustration below.
L1
L2
GROUND
Wiring diagram.
IMPORTANT NOTE: For electrical installation, attach the
conductors to the residence wiring in accordance with
National Electrical Codes and all state, provincial, munici-
pal and local codes.
This appliance must be installed in accordance with
National Electrical Codes, as well as all state, municipal
and local codes. The correct voltage, frequency and
amperage must be supplied to the appliance from a dedi-
cated, grounded circuit which is protected by a properly
sized circuit breaker or time delay fuse. The proper
voltage, frequency and power ratings are listed on the
product rating plate, located on the underside of the
cooktop. Refer to the illustration on page 3 for location of
the rating plate.
The complete appliance must be properly grounded at
all times when electrical power is applied.
Do not ground the appliance with the neutral (white)
house supply wire. A separate ground wire must be
utilized.
If aluminum house supply wiring is utilized, splice the
appliance copper wire to the aluminum house wiring
using special connectors design and agency certified
for joining copper and aluminum. Follow the connector
manufacturer's recommended procedure carefully.
Improper connection can result in a fire hazard.
6