GMC 2010 Yukon XL Denali Owner's Manual page 310

Using the Digit Dial Command
1. Press and hold
responds with Ready followed by a tone.
2. Say Digit Dial . The system responds with Digit
dial using <phone name>, please say the first digit
to dial followed by a tone.
3. Say the digit to be dialed one at a time. Following
each digit, the system will repeat back the digit it
heard followed by a tone.
4. Continue entering digits until the number to be
dialed is complete. After the whole number has
been entered, say Dial . The system responds
with OK, Dialing and dials the number.
If an unwanted number is recognized by the
system, say Clear at any time to clear the last
number.
To hear all of the numbers recognized by the
system, say Verify at any time and the system
will repeat them.
Using the Call Command
1. Press and hold
responds with Ready followed by a tone.
2. Say Call . The system responds with Call using
<phone name>. Please say the name tag followed
by a tone.
4-116
g
for two seconds. The system
g
for two seconds. The system
3. Say the name tag of the person to call.
If the system clearly recognizes the name tag it
responds with OK, calling, <name tag> and
dials the number.
If the system is unsure it recognizes the right
name tag, it confirms the name tag followed by
a tone. If the name tag is correct, say Yes .
The system responds with OK, calling, <name
tag> and dials the number. If the name tag is
not correct, say No . The system will ask for
the name tag to be re entered.
Once connected, the person called will be heard
through the audio speakers.
Using the Re dial Command
1. Press and hold
responds with Ready followed by a tone.
2. After the tone, say Re dial . The system responds
with Re dial using <phone name> and dials the
last number called from the connected Bluetooth
phone.
Once connected, the person called will be heard
through the audio speakers.
g
for two seconds. The system