Burner Control Box Lock-Out Reset Button; Hot Water Output Reduction (Dhw Only); Burner Does Not Ignite; Hotplate Insulating Covers - Stanley BRANDON DRY OIL Operation Instructions Manual

UNSCREW CAP IN
DIRECTION SHOWN
BURNER CONTROL BOX LOCK-OUT RESET
BUTTON
The control box reset button, located on the base
underneath the left hand door will illuminate if the
burner experiences a problem.
Press the button to reset the control box. If this
situation persists, contact your Service Engineer.
(See fig. 7)

HOT WATER OUTPUT REDUCTION (DHW ONLY)

Fig.5
The requirement for hot water differs from
household to household.
provided the temperature in the boiler will reach its
limit temperature and the appliance will shut down
until the limit stat is manually reset. The amount of
hot water provided can be reduced by hanging
optional boiler insulation panels to the boiler. (See
Fig. 8). These are available to order. The panels
can be hung individually or together for a further
reduction in boiler outputs.
When fitting both panels together, the panel must be
fitted to the left hand side first. Both panels are the
same size.
Fig.6
Fig.8

BURNER DOES NOT IGNITE

Check:
(a) that the electricity is switched on.
(b) that the oil supply valve is open and the line is
purged of air.
Fig.7
(c) that the thermostat reset button is pressed in.
(d) that the programmer is on and the thermostat is
calling for heat.
(e) that the "lock out" button on the control box at
the base of the cooker is not illuminated.
PLINTH
(f) If in doubt contact your local Stanley Engineer.
HOT PLATE INSULATING COVERS
The insulating covers retain most of the heat that
would otherwise be radiated into the kitchen. They
also retain the heat in the hot plates so that rapid
heating of cooking utensils will occur when one or
both of them are lifted for cooking purposes.
7
If excess hot water is