ZyXEL Communications P-2602HWUDL-D Quick Start Manual page 4

When the ZyXEL Device does not have power, the phone(s) connected to
the PHONE port can still be used for making PSTN calls.
3 PHONE: Use a telephone cable (and any telephone adaptor provided with your P-
2602HWUDL-D) to connect your telephone to this port.
4 USB 2.0: Connect a USB (version 2.0 or lower) memory stick for file sharing. The P-
2602HWUDL-D automatically detects the USB device.
5 USB 2.0: Use a USB cable (not provided) to connect a USB (version 2.0 or lower)
printer to this port.
6 ETHERNET 1-4: Use an Ethernet cable to connect a computer to this port for initial
configuration and/or Internet access.
7 Use the power adaptor provided with your P-2602HWUDL-D to connect an appropriate
power source to this socket.
8 Push the power switch to the on position.
Look at the LEDs (lights) on the top panel of the P-2602HWUDL-D.
• The POWER light blinks during start-up and is green once the P-2602HWUDL-D is ready.
• Each ETHERNET light turns on if the corresponding ETHERNET port is properly con-
nected. The lights blink when the P-2602HWUDL-D is sending or receiving data through
the corresponding ETHERNET port.
• The DSL light stays on if a physical connection with your DSL modem exists and blinks
when transmitting data. The INTERNET light stays on when Internet access is available.
• The PHONE lights stay on when your SIP account is registered and they blink if the
receiver is off the hook.
• The WLAN light turns on when the wireless LAN is ready. It blinks when the P-
2602HWUDL-D is sending/receiving data through the wireless LAN.
• The USB light turns on when there is a USB device (printer or memory stick) connected to
the P-2602HWUDL-D.
P-2602HWUDL-D Quick Start Guide
3