Westinghouse W-107 Owner's Manual page 4

MOUNTING AND WIRING INSTRUCTIONS
NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires. These
fixtures meet all UL specifications.
1. Turn off power at circuit box to avoid possible electric shock.
2. Secure mounting bar (A) to outlet box (B) with outlet box screws (C) (not included) (see fig. 1).
3. Thread hex nut (D) onto mounting nipple (E) approximately 1/4 inch and insert lock washer
(F), then thread mounting nipple (E) onto mounting bar (A) and secure with hex nut (D).
4. Slide fixture column (G) down fixture wires (H) (do not twist or kink wires), then thread
fixture column (G) onto coupling (I).
5. Open one link on bottom end of chain (J). Attach to fixture loop (K). Securely close link on
chain (J).
6. Thread screw collar ring (L) onto screw collar (M), then place canopy (N) over top of screw
collar (M).
7. Lace wires up through every other link on chain (J) then through screw collar (M) and
mounting nipple (E).
8. Open one link on top end of chain (J). Attach to loop on screw collar (M). Securely close
link on chain (J).
9. Identify color coding of fixture wires (see fig. 2).
10. To connect wires, take black fixture wire (group A from fig. 2) and place evenly against
black outlet box wire. Do not twist wires.
11. Fit wire connector (O from fig. 1) over wires and twist until there is a firm connection. If
wire connector (O) easily comes off, reattach and check again for a firm connection.
12. Repeat steps 10 and 11 with the white (group B from fig. 2) fixture wires and outlet box
wires.
13. Partially thread green grounding screw (P) into side hole (Q) on mounting bar (A) (see fig. 1).
14. Wrap ground wire from fixture around green grounding screw (P) leaving enough excess
wire to then connect ground wire and outlet box wire with wire connector (O) (see step 11).
15. Tighten green grounding screw (P). Do not over tighten.
16. Remove screw collar ring (L) from screw collar (M) and secure screw collar (M) to mounting
nipple (E).
17. Tuck wires inside outlet box (B).
18. Raise canopy (N) to ceiling and secure screw collar ring (L) to screw collar (M).
FIXTURE ASSEMBLY INSTRUCTIONS
Warning: This fixture is for indoor use only.
1. Place socket covers (R) over sockets (S) then place shades (T) over sockets (S).
2. Install lamps. Do not exceed recommended wattage.
3. Secure finial (U) to nipple (V) on fixture base (W).
4. Turn power back on at circuit box.
4