Physical Controls
USB Host / Client Port
Note:
USB Host / Client connection is made through an optional USB Serial Port if installed. The
connector is an industry-standard 9-pin "D" male connector.
The optional LXE USB cable is required to adapt the connection to a standard USB connector.
Please refer to section titled "Accessories" for the USB part number when ordering.
USB Host Cable
USB Host Cable, USB-A and D9F
MX3X Host Pin
1 Not Used
2 Not Used
3 To 3
4 Not Used
5 To 4
6 Not Used
7 To 2
8 Not Used
9 Not Used
E-EQ-MX3XRG-A
Do not connect a tethered scanner cable to an MX3X USB-C or USB-H labeled endcap
port. These ports cannot power a tethered scanner.
Figure 2-8 MX3X Serial Port and Compatible Cables
MX3XA068CBLD9
Signal
D + (Green Wire)
Ground (Black Wire)
D - (White Wire)
Figure 2-9 USB-Host to Serial Port Cable Pinouts
Host Port Label on MX3X
USB Host Pin
1 Not Used
2 From 7
3 From 3
4 From 5
5 Not Used
6 Not Used
7 Not Used
8 Not Used
9 Not Used
MX3X Reference Guide
41