Symphonic DVD/VCR Quick Setup Manual

Loading and Playing a DVD

1) Turn on the TV, amplifier and any other components connected to the unit.
2) Set the TV and audio receiver (commercially available) to the correct channel.
3) Press and confirm that the DVD OUTPUT indicator is lit.
If not, press to switch to DVD mode.
4) Press to open the disc loading tray and place the disc on
the tray, with the label side up.
5) Press .
The tray will close automatically and playback will start.
• For DVDs with a title menu recorded, the screen will display the title.
6) Press to stop playback.
Note:
• A "prohibited icon" may appear at the top-right on the TV screen during operation,
warning that a prohibited operation has been encountered by this unit or the disc.
Questions and Help on this products, please call
Help Line: 0870 383 3010 in the UK.

QUICK SETUP GUIDE

Congratulations on your purchase of a Symphonic DVD/VCR. This Quick Setup Guide takes
you through the first-time setup with simple instructions so you can enjoy exceptional audio and
video quality as soon as possible. Please refer to the Owner's manual for detailed instructions.
Unless stated, all procedures described use the remote control.

Loading Batteries in the Remote Control

1) Open the battery cover.

Connecting to a TV

VHF/UHF
UHF
MIXER
AERIAL
RF OUT
DVD
AERIAL
DIGITAL ANALOG S-VIDEO
AUDIO OUT AUDIO OUT OUT
VCR AV2 (DECODER)
L
OPTICAL COAXIAL DVD/VCR AV1 (TV) RF OUT
R
Only for the
model with
scart cable
OPTICAL jack RF cable
(supplied)
(supplied)
to 21-pin
scart jack
(TV) to aerial socket
PAL I_EN
2) Insert two R6 (AA) batteries, 3) Close the cover.
with the (+) and (-) ends
in the correct positions.
WARNING!
VHF
Never make or change connections with
the power switched on.
1) Disconnect the antenna or cable from the
TV and connect it to the AERIAL jack of the
VHF/UHF
unit.
MIXER
2) Connect the RF OUT jack of the unit
to the antenna in jack of the TV using the
supplied RF cable.
3) Connect the AV1 (TV) scart jack of the
unit to the scart input jack of the TV
using the supplied scart cable.
4) Plug in the TV and the unit.
Note:
• Playback picture from DVD and VCR
cannot be delivered through the RF
cable. The RF cable is only for sending
the antenna signal to the TV.
1VMN22596 *****