Controls And Features - Monogram ZV900 Owner's Manual

Controls
NOTE: Avoid using food products that produce
flames under the range hood.
1 POWER ON/OFF. Press to activate (turn
2 LIGHT DECREASE ON/OFF. Press to turn on
3 LIGHT INCREASE ON/OFF. Press to turn on
4 Display. Shows the fan setting.
5 FAN DECREASE ON/OFF. Press to turn on and
6 FAN INCREASE ON/OFF. Press to turn on and
6
on)/deactivate (turn off) the control buttons.
When the buttons are active (turned on), their
outer rings will be illuminated. When active
(turned on), the hood lights and fan will
automatically turn on at their last settings.
NOTES:
• Always deactivate (turn off) the buttons when
the hood is not in use.
• If both the LIGHT and FAN are set to OFF, the
buttons will automatically deactivate (turn off)
after 10 seconds.
and dim the lights. It remembers the last light
level used. The buttons allow you to cycle
around to the desired setting. (There are four
light levels/settings and OFF.)
and brighten the lights. It remembers the last
light level used. The buttons allow you to cycle
around to the desired setting. (There are four
light levels/settings and OFF.)
decrease fan settings. It remembers the last
fan level used. The buttons allow you to cycle
around to the desired setting. (Use to set the fan
speed to LOW, MED, HIGH, BOOST or OFF.)
increase fan settings. It remembers the last
fan level used. The buttons allow you to cycle
around to the desired setting. (Use to set the fan
speed to LOW, MED, HIGH, BOOST or OFF.)
BOOST—Provides five minutes at the maximum
fan setting and then automatically sets to HIGH
fan.
SENSOR FEATURE—The hood fan will
automatically turn on at the MED setting and
the display will show AUTO MODE ON if cooking
temperatures become too hot. The fan will stay
on for a minimum of 3 minutes and will then
turn off when temperatures cool to an
appropriate level.

Controls and Features

Glass Canopy Hood
-LIGHT+
1 2 3 4
1 LOCATE ON/OFF SWITCH. Grasp the filter
handle, press inward and then pull down.
Remove charcoal filter, if present. Reach into
the motor compartment and locate the
ON/OFF push-button switch on the side of the
motor. Press switch to OFF position.
Push-button
Switch
(vertical
view
from
inside
opening)
-FAN+
5 6