Set.u P; Speakers - Sony TRINITRON KV-20XBR Operating Instructions Manual

SET.U P
SPEAKERS
Placement
Attaching the speakers to the TV
. i
I
Right speaker
Left speaker
o
SPEAKER terminals
Turn the knobs on both sides
counterclockwise, adjust the
angle and then turn the knobs
clockwise to lock the speaker
in position.
The "APM" label should be right side up.
If desired, the speakers can be placed separately from
the TV by unfolding the stand.
Unfold
CJ
L
. Adjust the angle of the speakers, for best sound pro.
duction.
Caution
. Be sure to use speakers that are rated at 8-ohm im-
pedance with normal power holding capacity of more
than 7W for the KV-20XBR and of more than 10W for the
KV-25XBR.
. Make sure that none of the wire strands stick out,
making contact with the neighboring speaker terminals.
. If you have connected a pair of speakers other than
the supplied speakers, make sure to place the TV set at
a distance away from the speakers so that it will not be
affected by the speaker magnets. If a temporary prox-
imity to magnets should cause portions of the picture to
have poor color, turn the POWER off, and after about 10
minutes, turn it on again.
Speakers with low magnetic flux leakage such as the SS-X10A
speaker system (optional) may be placed near the set.
Connection
The speaker cord marked with a red line should be con-
nected to the EB (red) terminal and the cord unmarked to
the e (black) terminal for correct in-phase operation.
While pressing the
button, insert the
wire into the hole,
then release the
button.
~
Pull lightly on the
connection to make
sure it is secure.
Right speaker Left speaker
Speaker cords
If desired, larger 8-ohm speakers can be used as long as
they are rated at 8-ohm impedance.
Expose and twist the wire ends of the cords of your
speakers as illustrated below, and make the correct EB
e connections. For large speakers, set BASS BOOST
switch on the TV to "OFF" to prevent excessive bass.
~
~
5/8" (15mm)
Strip about 5/8" (15mm)
of the wire insulation
from the ends...
and then twist the
wire ends.
. Never connect an amplifier and this TV simulta-
neously to the speakers as this may damage the TV.
TV
Speaker system
Amplifier
5