Honeywell Sensepoint XCD Technical Manual page 41

Sensepoint XCD Technical Manual
Sensor type
Ir-1
Ir-3
Cb-1
Gas selection is dependent on the type of sensor attached to the XCD. If Ir-1/Ir-3 sensor
is attached, then a user can only select CO
is attached to the XCD, a user can select the gas from Str1 (1*) to Str8 (8*). For more
information on star rating, please refer to section 19.2.
The current configuration of the XCD is displayed and by using the '' switch to enter "SEL
gAS" menu. To select a flammable gas, use '' to move through the list, then use '' to
make the selection or abort function to discard the selection and return to menu mode.
If type of gas is changed, calibration prompt will appear to ask if you want to perform
calibration.
Gas type
CO
2
mEt
Str1 to Str8
2
Diagram 16: Gas Selection
Gas Name displayed
CO
2
mEt
FLM
/mEt gas respectively. But when Cb-1 sensor
41
SPXCDHMANEN Issue 2