Toyota 4-Runner 1985 Repair Manual page 448

AT-46 AUTOMATIC TRANSMISSION - Component Groups (Overdrive Case and Brake)
5. INSTALL THRUST BEARING AND RACES TO RING GEAR
AND SET RING GEAR IN OVERDRIVE CASE
NOTE: Make sure that the races are installed in the c,-
rect direction.
6. INSTALL CUSHION PLATE, DISCS, PLATES AND FLANGE
Flange
Using low-pressure compressed air, blow all excess ATF
Plate-t=~~~~}_+-
Disc
from the discs.
CAUTION: High-pressure air will damage the discs.
Install in order: Cushion plate (rounded end down)-plate-
disc-plate-disc-plate-disc-flange (flat end down)
7. INSTALL SNAP RING
Check that the ends of the snap ring are not aligned with
' - -_ _ _ _ _ _ _ _ _ _ _ _ _ -=C-=42::...:...J34
one of the cutouts.
8. MEASURE BRAKE CLEARANCE
Measure the distance between snap ring and flange.
Standard clearance: 0.65 - 2.21
mm
(0.0256 - 0.0870 in.)
9. INSTALL WASHER ONTO RING GEAR