Coupling And Tube Assembly - Roberts Gorden Energytube EM-115 Nstallation, Operation And Service Manual

Step 6.3 Coupling and Tube Assembly
A
Close coupling
with tab.
Open
Closed
C
Insert tubes into coupling.
Tube
Step 6.3.1 Coupling and Tube Assembly (Continued)
Tighten slide bar as shown below.
Correct slide bar
dimensions
• Repeat Step 6.3 A - D until all tubes are assembled. See Page 18, Section 6.3.2.
Tab
Orient coupling so that
the impact block is in the
2:00 or 10:00 o’clock
positions.
Tube
Drive slide bar until tight.
End of slide bar should be
within tolerance listed below.
± 2" (5 cm)
B
Start Slide bar/Coupling
Lock.
3" (8 cm) to
4" (10 cm)
D
Tighten coupling to join tubes.
Description Part Number
Coupling
Slide bar/Coupling Lock
Tube 91409XXX
Incorrect slide bar
position
SECTION 6: H I
EATER NSTALLATION
Slide Bar/Coupling Lock
Wide End
Coupling
Slide Bar/Coupling Lock
Coupling
Tube
01329600
01329700
17 of 71