Pentax LX Quick Help/Reference Manual page 16

Your LX camera is designed to accept a wide array of flash models using
either the built-in hotshoe of the standard FA-1 Viewfinder or the
synchronization terminals at the front of the camera body. The "X"
terminal is for synchronization of electronic flash or F-type and MF-type
bulbs; the "FP" terminal for synchronization with focal plane bulbs.
The LX system offers you the unique option of synchronization even with
non-dedicated electronic flash units with the shutter dial set at
"Automatic." In addition, manual speeds from "X" through "B" may be
used. On "Automatic" the synchronization range is between 1/30th second
and 4 seconds. Do not use "Automatic" for flash when the viewfinder
indicates a faster speed or the complete frame will not be exposed; be sure
to take precaution against picture blur when long exposures are indicated.
The chart below represents the usable synchronizations with both
electronic flash and bulb-type flash units
Shutter speed
Auto speeds
Electronic
flash
Manual speeds
FP-type bulbs
F-type, MF-type bulbs
CASE AND STRAP
Attaching the Strap
The strap which accompanies your LX can be used in two ways. Before attaching the strap, press the twin tab of the fastener (Tab A) with the edge of a
coin until the single tab (Tab B) protrudes.
To Carry the Camera Horizontally
When carrying the camera around your neck or when using the Standard Eveready Case, first attach one of the strap fasteners to either Accessory Lug C or
D and press Tab B with a coin until Tab A protrudes, thereby locking the fastener to the lug. Repeat with the other fastener.
To Carry the Camera Vertically
When you wish to carry the camera shoulder style, unlock the fastener attached to Accessory Lug C by pressing Tab B until Tab A protrudes. Then,
remove the fastener and attach it to Accessory Lug E.
IMPORTANT: Before carrying the camera by the strap, jiggle the fasteners back and forth while pulling on the strap to make sure that the fastener is
locked securely to the accessory lug. If not locked properly, the strap couJd come off and damage your camera.
CASE
The standard Eveready Case for your LX features a half-moon lock as added protection against coming open while carrying the camera. To remove the
case front cover, turn the cover a full 180° as shown so that the fastener unlocks, and separate.
CAUTION: Do not try to remove the front cover without first turning it so that the fastener unlocks (this could weaken or break the fastener).
GRIPS
1/2000 1/1000 1/500 1/125 X 1/60 1/30 1/15 1/8 1/4 1/2 1 2S
Usable speeds
4S