V-Pin And V-Cen Adjustment - Sony KV-30XBR910 Service Manual

Sony trinitron color television service manual
Hide thumbs Also See for KV-30XBR910:
Table of Contents

Advertisement

8. Set corner landing adjustments.
To get optimal landing, adjust LT, LB, RT, and RB with Service Data -/+
70.
NOTE: If landing adjustment exceeds the limit, as a last resort you can
adjust it by using the disk magnets.
Disk magnets
or rotatable disk
magnets correct
these areas (a-d)
Deflection yoke positioning
b
d

2-2. V-PIN AND V-CEN ADJUSTMENT

Preparation:
• Input a cross hatch pattern signal.
• Set Video Mode to: Standard (Reset)
• For all 4X3 CRT, VPIN data has separate register for full and V-
compress. Adjust both modes if needed.
1. Adjust service mode CXA2170D-1 05 V-CEN so that the top pin and
bottom pin are symmetrical from top to bottom.
2. Adjust service mode CXA2170D-1 06 V-PIN so that the top pin and
bottom pin are symmetrical from top to bottom.
3. Horizontal lines should be straight from left to right. Check landing for
side effect.
Purity control
corrects this area
a
b
c
d
corrects these areas
a
c
2-3. CONVERGENCE
Preparation:
• Set the CONTRAST and BRIGHTNESS control to standard (reset).
• Input a cross hatch pattern signal.
2-3.1. VERTICAL AND HORIZONTAL STATIC
CONVERGENCE
1. Disconnect the dynamic convergence before adjusting static
convergence (CN903), except for minor touch-up.
2. Adjust H.STAT convergence, RV9001, to converge red, green, and
blue dots in the center of the screen.
3. Connect dynamic convergence back.
4. Adjust V. STAT magnet to converge red, green and blue dots in the
center of the screen.
Center dot
R G B
5. Tilt the V.STAT magnet and adjust static convergence to open or close
the V.STAT magnet.
1
— 13 —
KV-30XBR910/34XBR910
R
G
B
RV9001
H-STAT
V.STAT magnet
B
B
G
G
R
R

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kv-34xbr910

Table of Contents