Download Print this page

Optional Cleaning Accessories; Troubleshooting - Kärcher K 1400 Operator's Manual

Karcher pressure washer operator manual

Advertisement

K1400 electric 6/27/02 6/27/02 10:01 AM Page 10
CLEANING TIPS –
continued
Barbecue Grills, Outdoor
Power Equipment &
Gardening Tools
(with or without detergent)
Pre-rinse cleaning surface with fresh water.
If using Kärcher All Purpose Cleaner or
Degreaser, place detergent suction tube
directly into cleaning solution and apply
detergent at low pressure. Allow Kärcher
detergent to remain on surface 1-3 minutes.
Do not allow detergent to dry on surface.
Rinse at high pressure keeping the spray
nozzle approximately 3-6 inches from the
cleaning surface. For removing extremely
stubborn dirt, it may be necessary to move
the spray nozzle even closer to the surface
for greater dirt cutting action. To remove
caked on mud from garbage cans, lawn
mower blades, wheel barrels or other
non-sensitive metal surfaces, you may
want to experiment with different settings on
the Quattro Nozzle.
9

OPTIONAL CLEANING ACCESSORIES

Optional cleaning accessories are available to further enhance your cleaning capabilities:
See accessories order form for product descriptions and ordering instructions.
• Vario Spray Wand
• House Washing Wand
• Extension Wand
• Flexible Spray Wand
• Underbody Spray Wand
• 4 Piece Extension Wand
In USA Call:
1-800-537-4129
or visit our website: www.karcher-usa.com
Patio & Lawn Furniture
(with or without detergent)
Pre-rinse furniture and surrounding area with
fresh water. If using Kärcher All Purpose
Cleaner, place detergent suction tube direct-
ly into cleaning solution and apply to surface
at low pressure. Allow Kärcher All Purpose
Cleaner to remain on surface 1-3 minutes.
Do not allow detergent to dry on surface. If
needed use special Wash Brush Attachment
to remove stubborn dirt. Rinse at high pres-
sure in a sweeping motion keeping the
spray nozzle approximately 3-6 inches from
the cleaning surface. For best results, clean
from top to bottom and from left to right.
Recommendations
• Before cleaning any surface an inconspic-
uous area should be cleaned to test spray
pattern and distance for maximum clean-
ing results.
• If painted surfaces are pealing or chipping,
use extreme caution as pressure washer
may remove the loose paint from the
surface.
• While using on surfaces which might come
in contact with food. Flush surfaces with
plenty of drinking water.
• Wet Sandblasting Attachment
• Pipe Drain Cleaner
• Water Suction Hose With Filter
• Extension Hose 25'
• Rotating Wash Brush
• K12 Surface Cleaner

TROUBLESHOOTING

Disconnect the machine from the power source before making any repair.
Symptom
Cause
Motor will not start.
On/Off switch is in the "OFF"
(O) position.
Power cord is not plugged in.
Extension cord is too long.
Extension cord is
not proper gauge.
Extension cord is damaged.
Electrical outlet does not supply
adequate power.
Ground Fault Circuit Interrupter
(GFCI) tripped.
Unit does not reach
Diameter of garden hose
is too small.
high pressure.
Water supply is restricted.
Not enough inlet water supply.
Water inlet filter is clogged.
Quattro Nozzle is in low
pressure position.
Wash brush is attached.
Output pressure
Not enough inlet water supply.
varies high and low.
Pump is sucking air.
Water inlet filter is clogged.
Discharge nozzle
is obstructed.
Calcified gun, hose
or Quattro Nozzle.
Solution
Turn switch to the "ON" (I) position.
Plug in power cord.
Replace extension cord with either
a 25 ft. 12/3 gauge cord or a 50 ft. 10/3
gauge cord.
Try a different outlet.
Reset breaker (power supply)
or GFCI.
Replace with a 3/4 inch
garden hose.
Check garden hose for kinks,
leaks and blockage.
Open water source full force.
10
Remove filter and rinse out
in warm water.
Turn Quattro Nozzle to high
pressure position.
Attach Quattro Nozzle.
Turn water on full force. Check garden
hose for kinks, leaks or blockage.
Check that hoses and fittings are air tight.
Turn off machine and purge pump by
squeezing trigger gun until a steady flow
of water emerges through the nozzle.
Remove filter and rinse out
in warm water.
Blow out or remove debris
with a fine needle.
Run distilled vinegar through
detergent suction tube.

Hide quick links:

Advertisement

loading