Advertisement
CLEANING TIPS
- continued
Barbecue Grills, Outdoor
Power Equipment &
Gardening Tools
(with or without detergent)
Pre-rinse cleaning surface with fresh water.
If using Kärcher All Purpose Cleaner or
Degreaser, place detergent suction tube
directly into cleaning solution and apply
detergent at low pressure. Allow Kärcher
detergent to remain on surface 1-3 minutes.
Do not allow detergent to dry on surface.
Rinse at high pressure keeping the spray
nozzle approximately 3-6 inches from the
cleaning surface. For removing extremely
stubborn dirt, it may be necessary to move
the spray nozzle even closer to the surface
for greater dirt cutting action. To remove
caked on mud from garbage cans, lawn
mower blades, wheel barrels or other
non-sensitive metal surfaces, you may
want to use the Karcher Rotating Nozzle
Spray Wand.
Caution: Do not use rotating nozzle spray
9
wand on cloth, plastic or other sensitive
surfaces as it may cause damage.
OPTIONAL CLEANING ACCESSORIES
Optional cleaning accessories are available to further enhance your cleaning capabilities:
See accessories order form for product descriptions and ordering instructions.
• Vario Spray Wand
• House Washing Wand
• Extension Wand
• Flexible Spray Wand
• Underbody Spray Wand
• 4 Piece Extension Wand
1-800-537-4129
or visit our website: www.karcher-usa.com
Patio & Lawn Furniture
(with or without detergent)
Pre-rinse furniture and surrounding area with
fresh water. If using Kärcher All Purpose
Cleaner, place detergent suction tube direct-
ly into cleaning solution and apply to surface
at low pressure. Allow Kärcher All Purpose
Cleaner to remain on surface 1-3 minutes.
Do not allow detergent to dry on surface. If
needed use special Wash Brush Attachment
to remove stubborn dirt. Rinse at high pres-
sure in a sweeping motion keeping the
spray nozzle approximately 3-6 inches from
the cleaning surface. For best results, clean
from top to bottom and from left to right.
Caution: Do not use rotating nozzle spray
wand on patio or lawn furniture as it may
cause damage.
Recommendations
• Before cleaning any surface an inconspic-
uous area should be cleaned to test spray
pattern and distance for maximum clean-
ing results.
• If painted surfaces are pealing or chipping,
use extreme caution as pressure washer
may remove the loose paint from the
surface.
• Wet Sandblasting Attachment
• Pipe Drain Cleaner
• Water Suction Hose With Filter
• Extension Hose 25'
• Rotating Wash Brush
• K12 Surface Cleaner
In USA Call:
TROUBLE SHOOTING
Symptom
Cause
Engine will not
No gasoline.
start
Low oil level.
Engine throttle is not in
correct position.
For additional
engine problems
refer to the engine
Pressure built up in the
owners manual.
high pressure washer.
Unit does not reach
Diameter of garden hose is
high pressure.
too small.
Water supply is restricted.
Not enough inlet water supply.
Water inlet filter is clogged.
Spray wand is in low
pressure position.
Output pressure
Not enough inlet water supply.
varies high and low.
Pump is sucking air.
Water inlet filter is clogged.
Discharge nozzle is
obstructed.
Calcified gun, hose or spray
wand.
Solution
Fill gas tank.
Add oil.
Position the throttle to "FAST".
Squeeze the trigger to release the
pressure.
Replace with a 3/4 inch garden
hose.
Check garden hose for kinks, leaks
and blockage.
Open water source full force.
Remove filter and rinse out in warm
water.
Turn spray wand tip to high pressure
position.
Turn water on full force. Check garden
hose for kinks, leaks or blockage.
Check that hoses and fittings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until
a steady flow of water emerges
through the nozzle.
Remove filter and rinse out in warm
water.
Blow out or remove debris with a
fine needle.
Run distilled vinegar through
detergent suction tube.
10
Hide quick links:
Advertisement
