Table of Contents
Advertisement
Brake Clamp
Figure 3.7.3
3.8
CHANGING FROM STANDARD CONFIGURATION TO AMPUTEE
SETTING
Figure 3.8.1
Amputee
M5 Nut and Bolt
Wheel mounting
Bracket
Standard
Figure 3.8.2
Figure 3.8.3
HANDY HINT: Work on one side at a time so the other side can be used as
reference for correct brake positioning.
NOTE:
If changing from amputee setting back to standard configuration
move the brake before replacing the quick-release wheels.
Page 11
Step 3: Use the larger bottom hole on
the block (see fig 3.3.3) to mount
the transit wheel. The block
should be pointing towards the
ground with the flat side of the
block facing outwards away from
the frame.
Transit Axle Block
Position
Wheel mounting
Bracket - Standard
Mount
Step 1: Remove hangers, quick-release
wheels and axles. Place
wheelchair on bench/table or
floor as shown in figure 3.8.1.
Antitipper
Step 2: Remove the two M6 nuts and
bolts with a 5mm allen key and
10mm spanner (as supplied in
Karma tool kit).
Step 3: Reposition wheel mounting
bracket as required. Replace
bolts, washers and nuts and
tighten. Replace quick-release
wheels, loosen brake clamps with
a 5mm allen key and slide along
frame to suit new wheel position.
the user can place their feet upon them.
Step 5:
Release the brakes.
CAUTION:
Never stand on the footplates when getting into or out of the
wheelchair.
Always ensure that the front castors are in line with the rear wheels and pointing
forwards and that the back of the wheelchair is secure against either a wall or firmly
held by an attendant.
2.2.2
Getting out
Step 1:
Make sure that the wheelchair is as close as possible to the transfer
point.
Step 2:
Back the wheelchair sufficiently to ensure that the castors are
pointing forward i.e. in line with the rear wheels and usually with the
castor forks pointing forward. Ensure that where possible the rear of
the wheelchair is against the wall or, if not, it must be firmly held by
an attendant.
Step 3:
Engage both the brakes.
Step 4:
Lift up the footplates and swing the footrests to the side.
Step 5:
Slide forwards on the seat.
Step 6:
Place one foot firmly on the ground with the knee at right angle and
the other foot slightly apart and further back.
Step 7:
Place your hands on the front of the armrests and moving your
weight forward, bring your head and shoulders up over your knees as
you push yourself up.
CAUTION:
Never stand on the footplate when getting out of or into the
wheelchair.
2.3
TRANSFERS
The following instructions apply to users with sufficient mobility to get in and out of
the wheelchair without assistance. However the instructions are still valid where
assistance is required and will help where other aids such as transfer boards or hoists
are used. Before transferring to or from the wheelchair, make sure you are as near as
possible to your point of transfer and that the brakes are applied.
Page 4
Advertisement
Table of Contents
