Method Of Coping With Shift Lens Error - Sony HDR-CX11E Service Manual

1-3. METHOD OF COPING WITH SHIFT LENS ERROR

LD-241 BOARD (SIDE B)
R5526
IC5501
R5534
Measurement points on the LD-241 board and the VC-535 board
1-3-1. E : 62 : 02 [Abnormality of IC for Steadyshot] Occurred
Order
1 Turn the power OFF.
While measuring with an oscilloscope the output voltage of R5549 in the periphery of IC5501 on the LD-241 board, turn the
2
power ON to check that the output voltage immediately after the power on change as shown in Fig. 2.
If the output voltage change as shown in Fig. 2, replace the lens block (Note). If it does not change as shown in Fig. 2, inspect
3
the camera control circuit (IC1301 of VC-535 board) periphery.
Note: When the lens block was replaced, execute a necessary adjustment items referring to Service Manual, ADJ.
After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the
handheld operation.
HDR-CX11E/CX12/CX12E_L2
VC-535 BOARD (SIDE A)
R5549
Fig. 1
about 330 msec
Note: The length of low section will vary a little depending on the
conditions.
Change in output voltage of R5549 on the LD-241 board
Procedure
1-3
ENGLISH JAPANESE
ENGLISH JAPANESE
Fig. 2
IC1301