Toshiba TOSVERT VF-MB1 Instruction Manual page 131

Setting of switching terminals
To switch to motor 2, assign the following functions to a terminal not being used. It is also possible to switch
to acceleration/deceleration 2 (AD2). Refer to section 6.15.1 for details.
It is possible to set 3 functions for terminal F and R, and 2 functions for terminal S1 and S2.
Input terminal function number
24 26 28
AD2 AD3 VF2
OFF OFF OFF
ON OFF OFF
OFF ON OFF
OFF OFF ON
OFF OFF OFF
Note 1: Each of the following numbers (25, 27, 29, 33) are reverse signals.
Note 2: Switching pt and "V/F constant" cannot be done while running. Stop the motor before changing.
vl and f170 , vlv and f171 , vb and f172 , thr and f173 can be switched while
running.
Note 3: Integral value of motor electronic thermal is kept, after the motor switching.
However, the setting that can memorize an integral value is possible.
Example of setting a terminal for switching : Sink logic
F (F: Forward run)
CC
S1(AD2)
S2(VF2)
R(OCS2)
Parameters changed from applicable parameters and
32
default standards 
OCS2
Default setting :
OFF
acc fs00、dec
OFF
acc fs10、dec
OFF
During stop : pt
vlv f171 , vb
OFF
During run : vl
f172 , thr
vb
f601 f185
ON
Forward run command
2nd acceleration/deceleration switch
2nd V/F setting switch
2nd stall prevention operation switch
F-11
E6581697
pt , vl , vlv , vb , thr , acc ,
dec , fs02 , f601
f501、f502
f511、f502
V/F constant , vl f170 ,
f172 , thr f173
f170 , vlv f171 ,
f173
fs03
fs12
6