HP 9000 rp3440 Installation Manual page 86

Cable Connections
Management Processor (MP)
NOTE
Step 7. The screen displays the current subnet mask name. When prompted to enter a new value or Q,
enter the new subnet mask name.
Step 8. The screen displays the current gateway address. When prompted to enter a new value or Q, enter
the new gateway address.
Step 9. The screen displays the current link state information. When prompted to enter a new value or Q,
press . The message -> Current Link State has been retained displays.
enter
Step 10. The screen displays the current Web console port number. When prompted to enter a new value or
Q, press
enter
displays.
Step 11. The screen displays the current SSH console port number. When prompted to enter a new value or
Q, press
enter
displays.
NOTE
Step 12. The screen displays a new LC listing, including the values entered in the preceding steps. Verify
that the desired values have been accepted. When prompted to enter a parameter for revision, Y to
confirm, or Q to Quit, enter Y to confirm all parameters.
> LAN Configuration has been updated
-> Reset MP (XD command option 'R') for configuration to take effect.
MP Host Name: mpserver
Step 13. Enter XD -reset to reset the MP.
Step 14. After the MP resets, log in to the MP again. Then enter the MP command mode (enter CM at the MP:
prompt).
Step 15. At the MP:CM> prompt, enter LS to confirm the new LAN settings.
Step 16. Enter SA to enable or disable Web console and telnet access after the MP has been reset.
The LC Command Screen
The following screen shows LC command output:
MP:CM> LC -nc
Current LAN Configuration:
MAC Address
DHCP Status
IP Address
MP Host Name
Subnet Mask
Gateway Address
Link State
86
The host name is not case sensitive.
. The message -> Current Web Console Port Number has been retained
. The message -> Current SSH Console Port Number has been retained
SSH settings will not display if you do not have Integrated Lights-Out Advanced
Pack licensing.
: 0x0060b0f54c51
: Enabled
: 127.1.1.1
: maestro
: 255.255.248.0
: 127.1.1.1
: Auto Negotiate
Chapter 4