13
Working with VPNs
Note
You can use IP40 Tele 8 only in NAT mode.
Setting up IP40 Tele 8
Configure a VPN Tunnel between an IP40 Tele 8 and an IP40 Satellite X.
On IP40 Tele 8 (VPN client) add a VPN site.
Setting up IP40 Satellite X
Configure a VPN Tunnel between an IP40 Tele 8 and an IP40 Satellite X.
To set up the IP40 Satellite X
1. Add a User.
2. Enable VPN remote access for the user you added.
3. Enable the VPN Server.
IP40 Tele 8 to Check Point v4.1/ NG/ FP1/ FP2/FP3/NG AI
The IP40 Tele 8 can be used as a VPN client to establish a VPN connectivity with a Check Point
server using version 4.1, NG, FP1, FP2, FP3 or NG AI.
Setting up IP40 Tele 8
Configure a VPN Tunnel between an IP40 Tele 8 and an IP40 Satellite X.
On IP40 Tele 8 (VPN client) add a VPN site.
Setting up Check Point Server
Open the Check Point policy editor and select Firewall-1/ VPN -1 workstation object that will
receive the Safe@VPN session request.
IP40 Tele 8 to Check Point NG AI
The IP40 Tele 8 can be used as a VPN client to establish a VPN connectivity with Check Point
NG AI server using a Safe@gateway dynamic object. This topology uses a remote access VPN
community.
An illustration of this topology is shown.
144
Nokia IP40 User Guide