Advertisement
6.2. Ensure that the engine is off, the fuel valve is closed, and the engine shroud is securely closed.
6.3. Rotate the drum into the tow position and secure the locking pin.
6.4. Extend tow pole and properly secure into position with securing pin and hitch pin.
6.5. Ensure that safety bolt is secured in place with lock washer and nut.
6.6. Secure the mixer hitch to the vehicle
6.7. Secure the safety chains to the vehicle.
MAXIMUM TOWING SPEED: 45 mph
7. SERVICING
7.1. Engine
7.1.1. See engine owner's manual for servicing instructions and maintenance schedule.
7.2. Mixer
7.2.1. Clean the drum after each use.
7.2.2. After cleaning, pull the locking pin to tip the drum forward and drain any excess water.
7.2.3. Return drum to tow position and secure with locking pin before moving mixer.
7.2.4. Grease all fittings daily.
7.2.5. Apply a light coat of crease to the gear teeth and idler arm at least once per week
8. MAINTENANCE SCHEDULE
Maintenance
Engine
Refer to engine operator/owner manual
Bearings
Grease and check
V-Belts
Check for wear
Gears
Grease and check
Hardware
Check and tighten
Tires
Check air pressure
8.1. Check all hardware after the first 4 hours of use then follow the standard maintenance schedule.
8.2. Tighten and check the shroud and axle hardware after the first 50 miles traveled, then follow the
standard maintenance schedule.
9. REPLACEMENT
Engine Components
V-Belts
Gears
Hardware
Safety decals
110103_ommortar
Refer to your engine manufacturer's operator/owner manual.
Replace stretched belts if the idler does not work properly.
Replace if cracked or worn
Replace if the teeth become cracked or become sharp.
Tighten all nuts and bolts after the first four (4) hours of operation
and check every twenty (20) hours of operation. Replace any
worn or damaged hardware as needed. Replacement hardware
should be grade 5 zinc plated.
Replace if they become damaged or illegible.
Instruction Manual – Mortar / Plaster Mixer
Each Use
Every 20
Hours
x
x
x
x
x
x
Yearly
x
x
x
x
x
x
5
Advertisement
