Mitsubishi Electric Mr.Slim PEH-2.5EAKH Operation Manual page 4

2. Parts Names
Wireless Remote-Controller
Remote controller display
* For explanation purposes, all of the items
that appear in the display are shown.
* All items are displayed when the Reset
button is pressed.
Set Temperature buttons
Fan Speed button (Changes fan)
Airflow button (Changes up/down airflow direction
Mode button (Changes operation )
When using the wireless remote controller, point it towards the receiver on the indoor unit.
If the remote controller is operated within approximately two minutes after power is sup-
plied to the indoor unit, the indoor unit may beep twice as the unit is performing the initial
automatic check.
The indoor unit beeps to confirm that the signal transmitted from the remote controller has
been received. Signals can be received up to approximately 7 meters in a direct line from
the indoor unit in an area 45° to the left and right of the unit. However, illumination such as
fluorescent lights and strong light can affect the ability of the indoor unit to receive signals.
If the operation lamp near the receiver on the indoor unit is flashing, the unit needs to be
inspected. Consult your dealer for service.
Handle the remote controller carefully! Do not drop the remote controller or subject it to
strong shocks. In addition, do not get the remote controller wet or leave it in a location with
high humidity.
To avoid misplacing the remote controller, install the holder included with the remote con-
troller on a wall and be sure to always place the remote controller in the holder after use.
Outdoor unit
Air intake
4
ON/OFF button
Check button
Test Run button
Air outlet
Service Panel
Transmission area
Transmission indicator
Timer indicator
Operation areas
Timer Off button
Timer On button
Hour button
Minute button
Set Time button (Sets the time)
Louver button (Changes left/right airflow direction)
Reset button
1. Remove the top cover, insert two AAA
batteries, and then install the top cover.
Top cover
2.Press the Reset button.
Power
Ref. Pipes
Indoor-Outdoor
Connection wire
Earth
Battery installation/replacement
Two AAA batteries
Insert the negative (–) end
of each battery first. Install
the batteries in the correct
directions (+, –)!
Press the Reset but-
ton with an object that
has a narrow end.