Cutting Blades; Abrasive Blades - Partner K650 ACTIVE III Operator's Manual

Table of Contents

Advertisement

CUTTING BLADES

General
Cutting blades are available in two standard designs; abrasive
discs and diamond blades
!
WARNING!
A cutting blade may burst and cause injury to
the operator.
High speed portable tools
Our cutting blades are manufactured for high-speed, portable
power cutters. If blades from other manufacturers are used,
ensure that the blades conform to all regulations and demands
that concern this type of power cutter.
!
WARNING!
Never use a cutting blade at a lower speed
rating than that of the power cutter.
Special blades
Some cutting blades are designed for stationary equipment and
for use with attachments.Such cutting blades must not be used
on portable power cutters.
!
WARNING!
Never use a cutting blade for any other
purpose than that it was intended for.
Always contact local authorities and make sure you are
following applicable directives.
SAFETY INSTRUCTIONS
Abrasive discs
The cutting material on abrasive discs consists of grit bonded
using an organic binder. "Reinforced blades" are made up of a
fabric or fibre base that prevents total breakage at maximum
working speed if the blade should be cracked or damaged. (The
term reinforced does not refer to those cutting blades that are
only reinforced around the flange).
A cutting blade's performance is determined by the type and
size of abrasive corn, and the type and hardness of the bonding
agent.
Characteristics that give the blade a shorter service life and
greater cutting capacity are said to make the blade "softer". A
blade with a longer service life and slower cutting capacity is a
blade with a "harder" effect.
High quality cutting blades are normally more economical.
Lower quality cutting blades usually have an inferior cutting
capacity and shorter service life, which results in higher cost per
processed material.
ABRASIVE DISCS, TYPES AND USES
General
Blade
characteristics
type
Universal
Con-
usage,
crete
economical.
Unbeatable for
Metal
steel (not
suitable for
concrete, etc.)
Use
Material
Water cooling
Concrete,
Can be used to
asphalt,
reduce dust.
stone,
The disc should
brickwork,
not be stored
cast iron,
after cutting is
aluminium,
complete as
copper,
water affects the
brass, cables,
strength of the
rubber, etc.
disc while
stored.
Steel, steel
NOT
alloys and
recommended.
other hard
metals.
English –
9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

K700 active iii

Table of Contents